PVC (Azek) vs Cement Board (James Hardie) - JLC Online
2010年5月7日 · Re: PVC (Azek) vs Cement Board (James Hardie) I also cracked an Azek fascia board by nailing through it with a gutter spike, I think the rafter tail was a bit soft so the azek …
Trimming a Vinyl Sided House with Azek - JLC Online
2019年12月30日 · Trimming a Vinyl Sided House with Azek - Avoiding the use of J-Channel 12-30-2019, 10:08 PM I'm working on a house that will be sided with a combination of …
Azek vs Aluminum wrap which way to go? - JLC-Online Forums
2004年3月25日 · Trying to determine if I would be better off using Azek solid material or wraping wood trim with aluminum. Would like feedback from those that have used both products, …
Trim for fiber-cement siding - JLC-Online Forums
2008年1月3日 · Re: Trim for fiber-cement siding Can't get Azek in these parts easily. Have used Tech Trim, which is a plastic foam product. It works, though it is expensive---more expensive …
Azek Trim & Joint Failures - JLC-Online Forums
2009年3月11日 · I recently used azek trim over hardie board ( the 4x8 stucco sheets) on roughly 10 dormers or bump-outs if you will. This was at the end of last summer early fall.I cut all the …
Notching 5/4 Azek - JLC-Online Forums
2006年11月1日 · Re: Notching 5/4 Azek I used azek for all the trim on my own house,with cedar impressions for the siding. i did a combination of a rabbet and padding the corners out.I used …
Water table/drip cap flashing detail - JLC-Online Forums
2019年2月10日 · There will be vycor behind the skirt board and then house wrap. Will there be any issues with putting on skirt board then bending aluminum drip cap over that and leave off …
Best caulk/sealant for wood to PVC trim joints - JLC Online
2010年3月24日 · Moderator: Bill Robinson Durable and leak-free details for siding and trim, doors and windows, roofs, decks and exterior finishes.
AZEK decking problems -sagging & raising - JLC-Online Forums
2014年10月12日 · The first problem is sagging of the AZEK decking between the skid plates. Since the skid plates are laid flat, the decking is only spanning 12-1/2". The AZEK reps are …
Azek trim and very cold temps? - JLC-Online Forums
2005年12月21日 · I used my laser to get my line at the base. Snapped a chalk line between points. I then cut the Tyvek out 1" below the line so the adhesive would adhere to the osb and …