1. Pilot hole diameter shall be 0.263” and drilled 1/4” longer than the necessary embedment. 2. Allowable loads are based ultimate test load divide by 4. 3. Recommended center to center distance of 3-3/4” is required for 100% efficiency and 1-7/8” for 50% efficiency. ANCHOR EMBEDMENT 1 TENSION Lbs. (kN) Tapcon®
2. Drill Hole – use selection chart to determine drill bit length and depth of hole. a) Choose appropriate drill of Tapcon Anchor. b) Drill hole minimum ¼” deeper than Tapcon Anchor to be embedded. Minimum anchor embedment: 1” Maximum anchor embedment: 1-3/4” 3. Drive Anchor. INSTALLATION STEPS Tapcon® Anchors APPROVAL/LISTINGS
Concrete Anchors & Fasteners - Tapcon
The drilled hole for a 3/16", 1/4" and 5/16" anchors requires a 1/4" deeper hole, and the 3/8" and 1/2" anchors require a 1/2" deeper hole. This will ensure that any dust that settles in the hole will not interfere with the Tapcon threads.
• Ensure the precise drilling of pilot holes when installing Tapcon anchors. • Masonry drill bits with a carbide tip. • Tapcon drill bits are sold separately and are also included in the large packages of anchors (at select stores only). • Colorstripe on drill bit package corresponds to Tapcon Packaging.-For installing 1/4" Tapcon ...
Tapcon+ Screw Anchor - Technical Data Characteristic Symbol Units Nominal Anchor Diameter (inch) 1/2 Location of installation - - Lower Flute Upper Flute Minimum hole depth hhole in. 2 1/2 4 1/2 2 1/2 Nominal embedment depth hnom in. 2 4 2 Minimum effective embedment depth hef in. 1.32 3.02 1.32 Characteristic pullout strength, uncracked concrete over metal deck Np, deck,uncr lbf 1,720 4,950 2,405
Tapcon SDS Plus Drill Bits are specially designed to be compatible with Condrive Pro Installation Kit. Use the Tapcon bits and Condrive Pro together to install Tapcon anchors for optimal performance.
Lengths of Tapcon Anchors range from 1-1/4” to 4” in 3/16” and up to 6” in 1/4” diameters. Nail-Type Point guides the anchor into the pre-drilled hole. Excellent for wood to concrete applications. Read installation instructions before using!
Use the charts below to select the correct drill bit. Clean Hole. Using a blow out bulb or compressed air, remove dust from hole. Drive anchor using a hammer drill with nut driver or Phillips bit until fully seated. For faster and easier installation, use a Tapcon® Condrive® installation tool. use the color-coded Tapcon Drill Bit.
Standard Drill Bits & SDS Drill Bits - Tapcon
How many pilot holes can I expect to get out of a Tapcon drill bit? A straight shank Tapcon drill bit can be expected to drill 60 holes minimum to a 2" depth in 4,000 psi concrete. A SDS shank Tapcon drill bit can be expected to drill 100 holes minimum to full depth in 4,000 psi concrete.
Tapcon Drill Bit Sizes Chart - Yard and Garden Guru
2022年3月23日 · In our guide, you can use our Tapcon drill bit size chart to get the right Tapcon drill bit size. By the end, you’ll be able to find the right drills and drill bits to get the strongest holding threads that offer an accurate fit, thus obtaining higher …
- 某些结果已被删除