It is used to compare two different voltages, namely, reference voltage and MQ-6 gas sensor output voltage. Reference voltage at non-inverting pin 3 of IC2 is set using potentiometer VR1 to adjust ...

Republican Rep. Nancy Mace (S.C.) introduced a measure to ban transgender women from using the women’s bathrooms at the Capitol, just weeks after the state of Delaware elected the first openly ...

This repository contains the implementation of a motor speed control system using an FPGA. The speed is adjusted dynamically through a potentiometer, leveraging ADC for analog-to-digital conversion ...

Programming can be done via the integrated programmer/debugger using the FTDI module FT2232HL or an external adapter connected to the JTAG connector. Furthermore, the board includes a gate driver and ...

A high speed stepper library for Atmega 168/328p (nano), Atmega32u4, Atmega 2560, ESP32, ESP32S2, ESP32S3, ESP32C3, ESP32C6 and Atmel SAM Due ...

You can handle all Corsair items from this program. The primary disadvantage is that this software can only control Corsair devices such as Corsair keyboards. Besides this, it’s a fantastic app to use ...

So, [lhartmann] chose to use the I2S outputs ... That’s more than enough signals to run the stepper motors. And since it updates at 192 kHz sample rate, it’s plenty fast enough to drive ...

[Ken]’s Easy Stepper Motor Controller is a much simpler solution to the problem of testing these drivers and could, with a bit of practice, be constructed on a single-sided homebrew PCB.